Search command

    Purpose:  Searches the range for the character(s) in the list.

    Format:   S range list

    Remarks:  All matches are indicated by displaying the addresses where
              matches are found.

              A display of the prompt (-) without an address means that
              no match was found.

                   Note:
                   If you enter only an offset for the starting address
                   of the range, the S command assumes the segment con-
                   tained in the DS register.

    Example:  If you want to search the range of addresses from CS:100h
              through CS:110h for 41h, type

              S CS:100 110 41

              If two matches are found the response might be:

              04BA:0104
              04BA:010D

              If you want to search the same range of addresses as in the
              previous example for a match with the 4-byte-long list,
              enter:

              S CS:100 L 11 41 "AB" E

              The starting addresses of all matches are listed. If no match
              is found, no address is displayed.